Aux send master section, Aux send controls, Monitor/aux send 5-6 control – Yamaha RM800 User Manual
Page 9: To st switch
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1
Touring Around RM800
RM800 User's Guide
Aux Send Master Section
TOST
0 ' '10
MONITOR/
AUX SEND 5-6
(2)
© AUX SEND Controls
These are the AUX SEND master level controls. They control the level of the
signals sent to the AUX SEND connectors. Use them to set the level of the sig
nals sent to your effects processors or whatever else you have connected to the
aux sends. The fat dial mark at 3 o’ clock indicates the unity gain setting (i.e.
no gain, no attenuation).
© MONITOR/AUX SEND 5-6 Control
This is the MONITOR/AUX SEND 5-6 master level control. It controls the
level of the signal sent to the MONIOUT/AUX SEND 5-6 connectors. It does
not affect the TO ST signals. If you are using the MONITOR/AUX SEND 5-6
functions to set up a headphone mix, then this control is used to set the overall
level of that headphone mix. If, on the other hand, you are using them as AUX
SENDs 5 and 6, it controls the signal level sent to your effects processors.
© TO ST Switch
This switch sends the MONI/AUX SEND 5-6 signals to the STEREO bus. In
conjunction with the MONI/AUX SEND 5-6 level and PAN controls on each
input module, this allows you to monitor recorded tracks in the control room
monitors, and still use the MIC/LINE input section of an input module for
more recording. For example, multitrack track 5 can be monitored using the
MONI/AUX SEND 5-6 level and PAN controls on input module 5 while other
sources connected to input module 5’s MIC/LINE inputs are sent to other
tracks for recording. In this case, the M/L-TAPE switches next to GAIN con
trols are set to M/L (i.e. MIC/LINE signals are sent to the EQ and fader) and
the M/L-TAPE switches next to the MONI/AUX SEND 5-6 controls are set to
TAPE (i.e. multitrack signals are sent to the MONI/AUX SEND 5-6 controls).
At mixdown, sending the MONI/AUX SEND 5-6 signals to the STEREO bus
allows you to send all MIC/LINE and TAPE IN signals to the stereo mix.
Including the four stereo AUX RETURNS, that’s 40 inputs on RM800-16, and
56 on RM800-24 at mixdown. In this case, the M/L-TAPE switches next to
GAIN controls are set to TAPE (i.e. multitrack signals are sent to the EQ and
fader) and the M/L-TAPE switches next to the MONI/AUX SEND 5-6 controls
are set to M/L (i.ei MIC/LINE signals are sent to the MONI/AUX SEND 5-6
controls).