Aviom 6416m/RCI/MCS - Manual (Page 117)

106 A
dvAnced
F
unctions
The 6416m Control Master status is controlled by the rear‑panel DIP switch
#10 setting. This is not changed when the factory defaults are restored.
VDC configuration for GPIO type—Isolated or TTL—is not reset. VDC baud
rate, parity, and stop bit settings for RS‑232 communication are not reset.
These are hardware settings configured via the DIP switches in the VDC
section of the rear‑panel part of the interface.
Restoring factory defaults is a local function; only the module where the
function is engaged will be reset.