Aviom 6416m/RCI/MCS - Manual (Page 15)

4 M
AintAining
Y
our
P
ro
64 P
roduct
Transporting the 6416m in a Rack
The 6416m Mic Input Module has attachment points for rear support
hardware built into the product’s sides. If the 6416m is to be rack mounted
and transported frequently, be sure to support the rear of the unit with
appropriate mounting hardware that matches the size of the rack used to
avoid damage to the product.
Ventilation
The 6416m is convection cooled and does not require a built‑in fan. Always
allow adequate ventilation for devices mounted in equipment racks. Avoid
placing your Pro64 product directly above or below other rack‑mounted
devices that produce high levels of heat, such as power amplifiers.
Do not block the side and back vented openings in the product’s case. The
openings in the top may be blocked as long as the temperature immediately
around the unit remains below 50°C. Although use in ambient temperatures
exceeding 50°C isn’t recommended, leaving an open rack space above the
unit will provide additional margin in extreme temperature conditions.
Cleaning
Before cleaning a Pro64 product, turn off the power switch and unplug the
unit from the AC power source.
To clean the surface of the Pro64 product use a clean, soft lint‑free cloth that
has been slightly moistened with water only. For tougher dirt, use a cloth
slightly dampened with water or with a mild detergent. Always be sure to dry
the surface of the unit before proceeding with use.
When cleaning your Aviom products, never spray cleaners directly onto the
product surfaces. Instead, spray a small amount of the cleaning solution onto
a clean cloth first. Then use the dampened cloth to clean the product.
Never use solvents or abrasive cleaners on the finished surfaces of your
Aviom products.