Aviom 6416m/RCI/MCS - Manual (Page 93)

82 Mcs F
eAtures
No
Control
The current gain setting is displayed for any active mic preamp channel when
its Slot is selected.
Gain Control
The rotary gain control sets the amount of gain applied to the currently
selected mic preamp channel and can be changed in 1dB increments. The
gain display will flash until the 6416m has processed the command sent from
the MCS. Gain settings for each channel of the 6461m are saved within a mic
preamp Preset.
Mute Button
Use the Mute button to silence an active mic preamp channel while leaving
it active in the network. Press the M
utE
button once to enable the mute
function; press M
utE
again to release the channel from the muted state.
The Mute state is saved as part of a mic pre Preset.
Phase Button
Press the Phase button to invert the polarity of the input signal on the
selected mic preamp channel. Use the Phase button to eliminate anomalies
that occur when using two or more microphones on the same source (such
as a drum kit).
To change the phase, press the P
hasE
button once; its yellow LED will light
to indicate that the function is enabled. It is not necessary to press Enter. To
return the audio on the selected channel to its original state, press P
hasE
again, the LED will go out.
The state of the Phase button is saved with a mic pre Preset.