A-net slot range configuration, Setting the a-net slot range – Aviom 6416m/RCI/MCS User Manual
Page 46
35
n
etwork
s
ettings
A-Net Slot Range Configuration
The A‑Net Slot section of the interface is used to set the range of A‑Net Slots
that the 6416m will use to send its active audio channels into the network.
There are two components: the A‑Net Slot display and the inc/dec buttons
used to select a value.
6416
m
A-NET SLOT
Edit Lock
Managed
Edit
CONTROL
MASTER
ENTER
CANCEL
Gain
(dB)
Port A
Port B
Auto
A-NET
TRANSMIT
Manual
VDC SLOT
RS-232
MIDI In
MIDI Out
GPIO In
GPIO Out
ASSIGN
PORT
CLOCK
MASTER
CONTROL
Sample Rate
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Link
Link
Link
Link
Link
Link
Link
Link
Mute
Edit
Mute
Edit
Mute
+48V
Phase
Low Cut
SAVE
RECALL
Pad
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Ø
Pad
+48V
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Edit
Mute
Mute
Mute
Mute
Edit
Edit
Edit
Edit
Mute
Edit
Mute
Edit
Mute
FUNCTION
Group 4
Group 3
Group 2
Press the up/down buttons to select an A-Net Slot range.
The A‑Net Slot display will move in increments of sixteen Slots and the A‑Net
Slot range display will wrap as it reaches the end of the list of available values.
The number shown in the display corresponds to the base Slot in a group of
sixteen sequential Slots, one per channel button. The available base Slots are
1, 17, 33, and 49.
Base Slot Displayed
A-Net Slot Range
01
Slots 1‑16
17
Slots 17‑32
33
Slots 33‑48
49
Slots 49‑64
Keep in mind that the number of available Slots is determined by the current
network sample rate as set by the Clock Master.
Setting the A-Net Slot Range
To set a base range for the 6416m, use the inc/dec selection buttons found
below the A‑Net Slot display to select the desired range. When the selection
button is pressed, the new base Slot number will start to blink in the display,
as will the Enter/Cancel button’s LED. This indicates that confirmation is
required to complete the change. Press
E
ntEr
to set a new base Slot or press
C
anCEl
to exit without changing the base Slot and return to the previous
setting. If no press of the Enter/Cancel button is detected within a brief
period of time, the interface will automatically cancel the change request,
returning to the previous state.
Setting a new base Slot range on the 6416m will deactivate any currently
active channels.