Hardy HI 200DNWM DeviceNet Weigh Module - Manual (Page 5)

Table of Contents
iii
CHAPTER 6 - CALIBRATION - - - - - - - - - - - - - - - - -6-1
SCOPE - - - - - - - - - - - - - - - - - - - - - - - - - - - -6-1
Pre-Calibration Procedures - - - - - - - - - - - - - - - - - - -6-1
C2® Calibration (The Button) - - - - - - - - - - - - - - - - - -6-1
C2® Calibration from RS NetWorx
® - - - - - - - - - - - - - -6-2
Test Weight Calibration from RS NetWorx
®
- - - - - - - - - - -6-3
CHAPTER 7 - OPERATION - - - - - - - - - - - - - - - - - -7-1
SCOPE - - - - - - - - - - - - - - - - - - - - - - - - - - - -7-1
Operating Capabilities - - - - - - - - - - - - - - - - - - - - -7-1
Explicit Message Request Parameters - - - - - - - - - - - - -7-1
Monitoring Weight Readings from RS NetWorx - - - - - - - - -7-2
Network Status (DS1) - - - - - - - - - - - - - - - - - - -7-2
Module Status (DS2) - - - - - - - - - - - - - - - - - - - -7-3
CHAPTER 8 - TROUBLESHOOTING - - - - - - - - - - - - -8-1
SCOPE - - - - - - - - - - - - - - - - - - - - - - - - - - - -8-1
Module LED does not Come Back on When Performing
Calibration with The Button - - - - - - - - - - - - - - - - - -8-1
Module LED is Flashing Red - - - - - - - - - - - - - - - - - -8-1
Mechanical Inspection - - - - - - - - - - - - - - - - - - - - -8-1
Load Sharing and Load Sensor Checkout - - - - - - - - - - - -8-3
Guidelines for Instabilities on Formerly Operating Systems - - -8-4
Electrical 8-5
Mechanical Stability and Configuration Settings - - - - - - - - -8-6
INDEX