ALTANA Haze-Gard Dual - Manual (Page 25)

24
English
7.1 ISO Method
If the “transm. + haze” parameter is
selected, the device is ready to
carry out measurements in accor-
dance with the ISO method. The
comp-port is open. Press the “ope-
rate” button. You will then be re-
quested to place the specimen at
the comp-port.
The specimen must be held level
with the port during measurement.
Press the “operate” button. The
device will start measuring. The
following message appears during
measurement:
“Measurement active”.
You will then be requested to place
the specimen at the haze port.
Place the specimen at the haze port
and press the “operate” button.
The following message is displayed
again:
“Measurement active”.
The result is displayed and the
measurement process is complete.
Transmission measurement is iden-
tical to the measurement procedure
described above.
Place
sample at
comp-port
Ready: OPERATE
Please place
sample at
haze-port
Ready: OPERATE
ISO
T
H
91.8
18.3
7 Measurement