ALTANA Haze-Gard Dual - Manual (Page 31)

30
English
reference
ISO
T
89.5
CONT. MODE
Standby-Mode
To add a value to the statistics,
press the “operate” button. The
following message appears on the
display:
Measurement active.
The device will then return to
Continuous Mode on completion.
If you change the material to be
tested, the transmission must be
redefined.
Indicate the change by pressing the
“reference” button.
A message on the display will
request you to place the specimen
in the haze port.
The device will then return to
Continuous Mode.
Standby
To protect the lamp, Continuous
Mode is interrupted after a certain
period if the device fails to establish
any change in the measurement
value at the beam aperture.
Measurement is continued if a
significant change is detected at the
beam inlet (e.g. placing of a
specimen).
OPERATE
Transmittance
Measurement
Please place
Sample at
haze-port
Ready:
9 Continuous Mode