ALTANA Haze-Gard Dual - Manual (Page 30)

29
English
reference
OPERATE
Transmittance
Measurement
Please place
Sample at
haze-port
Ready:
ISO
H n= 11
m= 14.6
s= 1.16
15.8
CONT. MODE
To add a value to the statistics,
press the “operate” button. The
following message appears on the
display:
Measurement active.
The device will return to continuous
mode. If the statistic function is acti-
vated (Chapter 8.3), the counter will
increase by one after measurement.
If you change the material to be
measured, a new compensation
measurement is required. Indicate
the change by pressing the “refer-
ence” button.
You will be asked to place the spe-
pensation measurement is triggered
by pressing the “operate” button.
The device will then return to conti-
nuous mode.
Haze
The haze measurement requires the
value of the total transmittance as a
reference for the measured speci-
men. This is indicated in a message
on the display. Place the specimen
whose total transmittance is to be
defined at the haze-port.
The device will return to Continuous
Mode on completion.
OPERATE
Measurement
Place
Sample at
comp-port
Ready:
Compensation
cimen in the comp-port. The com-
9 Continuous Mode