Automatic buttonhole, Automatic buttonhole -78 – Kenmore 385.162213 User Manual
Page 86
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SECTION Vn. BUTTONHOLE
Automatic Buttonhole
(X> stitch selector:
(2) Stitch width:
(3) Stitch length:
0 Needle thread tension:
0 Presser foot R:
U (BH)
3 to 6,5
0.25 to 1.0
2 to 6
Automatic buttonhole foot
Preparation for sewing
(3) Groove
@ Pin
Attach the automatic buttonhole foot R, Make sure the
groove on the foot holder catches the pin on the foot when
lowering the presser foot.
To sew
0 Button holder
@ Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1 0”
(2.5 cm) in diameter.
Make a test buttonhole on an extra piece of the fabric to
check your settings.
Use interfacing on stretch fabrics.
rn Pull the button ho!der0to the back, and place the
button in it. Push it forward tightly against the button..
Pull the buttonhole lever(|)down as far as it will go