Kenmore 385.162213 User Manual
Page 90
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
!f the button is extremely thick, make a test buttonhole,
if it is difficult to fit the button through the test buttonhole,
lengthen the buttonhole by pulling the button holder back to
create a gap (T) -
¿Gap
0
How to adjust buttonhole stitch density
Slide the stitch length control to adjust stitch density,
Slide the stitch length control to 1 for a looser density®..
Slide the stitch length control to 0,25 for a tighter density
If the sides of the buttonhole are not balanced, do the
following:
• If the buttonhole looks like ®, use the screwdriver to
move the lever to the right (+) to make the left side
of the buttonhole less dense {see illustration).
" if the buttonhole looks like ®, use the screwdriver to
move the lever to the left (-) to make the left side of the
buttonhole denser.
(6) Buttonhole pitch balance adjusting lever