Comtrol ES7510-XT - Manual (Page 103)

RocketLinx ES7510-XT User Guide: 2000571 Rev. D DSCP-Queue Mapping - 103
Configuration Using the Web Interface
DSCP-Queue Mapping
Use this page to change DSCP values to Physical Queue mapping table. Since the switch fabric of the ES7510-
XT only supports four queues. Lowest, Low, Middle and High users should therefore assign how to map DSCP
values to the level of the physical queue. You should therefore assign how to map DSCP value to the level of
the queue. You can change the mapping table to follow the upper layer 3 switch or routers’ DSCP setting.
After configuration, press Apply to enable the settings.
Note: You must Save the settings ( Page 130 ), if you want to maintain these settings if the ES7510-XT is
powered off.