E cli, Show running configuration – Comtrol ES7510-XT User Manual
Page 149
RocketLinx ES7510-XT User Guide: 2000571
Rev. D
Basic Settings (CLI) - 149
Configuration Using the Command Line Interface (CLI)
Backup and Restore
Backup Startup
Configuration File
Switch# copy startup-config tftp: 192.168.250.33/
default.conf
Writing Configuration [OK]
Note: To backup the latest startup configuration file, you should save current
settings to flash first. You can refer to
on Page 130 to see
how to save settings to the flash.
In the example above, 192.168.250.33 is the TFTP server’s IP and
default.conf is name of the configuration file. Your environment may use
different IP addresses or different file name. Type target TFTP server IP
or file name in this command.
Restore Configuration
Switch# copy tftp: 192.168.250.33/default.conf startup-
config
Show Startup
Configuration
Switch# show startup-config
Show Running
Configuration
Switch# show running-config
Firmware Upgrade
Firmware Upgrade
Switch# archive download-sw /overwrite tftp 192.168.11.33
ES7510-XT.bin
Firmware upgrading, don't turn off the switch!
Tftping file ES7510-XT.bin
Firmware upgrading
............................................................
....................
............................................................
....................
...........................
Firmware upgrade success!!
Rebooting.......
Load Default
Load Default
Switch# reload default-config file
Reload OK!
Switch# reboot
System Reboot
Reboot
Switch# reboot