Comtrol ES7510-XT - Manual (Page 151)

RocketLinx ES7510-XT User Guide: 2000571 Rev. D Port Configuration (CLI) - 151
Configuration Using the Command Line Interface (CLI)
Port Control (continued)
Port Control
– Flow
Control
Switch(config-if)# flowcontrol on
Flowcontrol on for port 1 set ok!
Switch(config-if)# flowcontrol off
Flowcontrol off for port 1 set ok!
Port Status
Switch# show interface fa1
Interface fastethernet1
Administrative Status : Enable
Operating Status : Connected
Duplex : Full
Speed : 100
Flow Control :off
Default Port VLAN ID: 1
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Disable
Loopback Mode : None
STP Status: forwarding
Default CoS Value for untagged packets is 0.
Mdix mode is Disable.
Medium mode is Copper.
Switch# show sfp ddm
show SFP DDM information
Port 9
Temperature:N/A
Tx power:N/A
Rx power:N/A
Port 10
Temperature:64.00 C <range :0.0-80.00>
Tx power:-6.0 dBm <range : -9.0 - -4.0>
Rx power:-30.0 dBm <range: -30.0 - -4.0>
Note: Administrative Status -> Port state of the port. Operating status -> Current status of the
port. Duplex -> Duplex mode of the port. Speed -> Speed mode of the port. Flow control -
> Flow Control status of the port.
Rate Control
– Ingress or
Egress
Switch(config-if)# rate-limit
egress Outgoing packets
ingress Incoming packets
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.