Comtrol ES7510-XT - Manual (Page 56)

56 - DHCP Server Configuration RocketLinx ES7510-XT User Guide: 2000571 Rev. D
Configuration Using the Web Interface
Subnet Mask Enter the subnet mask for the DHCP server.
Default Gateway Enter the IP gateway address for the DHCP server.
Lease Time Enter the Lease Time in seconds for the client.
Apply
Click Apply to apply the settings.
Note: You must Save the settings ( Page 130 ), if you want to maintain these
settings if the ES7510-XT is powered off.
Excluded Address
IP Address
You can type a specific address into the IP Address field for the DHCP server
reserved IP address.
The IP address that is listed in the Excluded Address List Table is not assigned
to the network device. Add or remove an IP address from the Excluded Address
List by clicking Add or Remove.
Manual Binding
IP Address
The ES7510-XT provides an IP address binding and removing function. Enter
the specified IP address, and then click Add to add a new IP address binding
rule for a specified link partner, like a PLC, or any device without DHCP client
function.
To remove an IP address from the Manual Binding List, highlight the rule and
click Remove.
MAC Address
The ES7510-XT provides a MAC address binding and removing function.
Enter the specified MAC address, and then click Add to add a new MAC
address binding rule for a specified link partner, like a PLC, or any device
without DHCP client function.
The MAC address format is xxxx.xxxx.xxxx; for example, 00C0.4E38.0001.
To remove a MAC address from the Manual Binding List, highlight the rule
and click Remove.
Port and IP Address
Port Enter the client port number for the DHCP server.
IP Address
Enter the client IP address for the DHCP server.
After entering the port number and IP address, click Add. To remove a port
and associated IP address, click Remove. Click Reload to reload selected port
and IP address entries.
Option82 IP Address Configuration
IP Address
Option 82 IP Address Configuration: fully supports DHCP relay function.
The IP address of the Option82 IP address configuration.
Circuit ID The Circuit ID of the Option82 IP address configuration.
Remote ID
The Remote ID of the Option82 IP address configuration.
After entering the IP Address, Circuit ID, and Remote ID, click Add.
Click the Remove button to remove selected Option82 IP Address table entries.
Click the Reload button to reload selected Option82 IP Address table entries.
Type This displays string or hex, depending on the type.
DHCP Server Configuration Page (Continued)