Comtrol ES7510-XT - Manual (Page 153)

RocketLinx ES7510-XT User Guide: 2000571 Rev. D Power over Ethernet (CLI) - 153
Configuration Using the Command Line Interface (CLI)
Power over Ethernet (CLI)
Power over Ethernet is one of the key features of ES7510-XT. It is fully IEEE 802.3af compliant, and supports
IEEE 802.3at, including two-event and LLDP classification. The ES7510-XT supports up to 8Port PoE
injectors in Port 1 to Port 8, each port with the ability to deliver 30W of power.
For more information or to use the web user interface, see Power over Ethernet on Page 73.
This table provides detailed information about the CLI commands for PoE control.
PoE System Status
Display
Switch# show poe
interface Status of interface
pd-detect Status of PD status detection
schedule Status of PoE schedule
system Status of poe system
Switch# show poe system
PoE System
PoE Admin : Enable
PoE Hardware : Normal
PoE Input Voltage :
Vmain 1 : 48.3 V
Output power : 10.1 Watts
Temperature 1 : 43 degree C
Power information :
Emergency power :
Primary : DC1(48 V), DC2(48 V)
Secondary : N/A
Tertiary : N/A
Power Budget : Managed
Budget :
DC Power 1 : 0 Watts
DC Power 2 : 120 Watts (In Use)
Total : 120 Watts in Use
Power Budget Warning Level : 75 %
Utilization : 8 %
Event : Normal
PoE PD Detection
Status
Switch# show poe pd-detect
PD Status Detection
Status : Enabled
Host 1 :
Target IP : 192.168.250.100
Cycle Time : 10
Host 2 :
Target IP : 192.168.250.200
Cycle Time : 20