Connect the ethernet ports – Comtrol ES7510-XT User Manual
Page 13
RocketLinx ES7510-XT User Guide: 2000571
Rev. D
Connect the Ethernet Ports - 13
Hardware Installation
Connect the Ethernet Ports
You can use the following information to connect standard Ethernet cables between the ES7510-XT Ethernet
ports and the network nodes.
•
Ports 1-8 are Fast Ethernet (10/100BASE-TX) PoE ports that are IEEE 802.3af (PoE) and IEEE 802.3at
(PoE Plus) compliant.
•
Ports 9-10 are RJ45/SFP Combo Gigabit ports that support 10/100/1000BASE-TX, 100BASE-FX, and
1000BASE-X with digital diagnostic monitoring (DDM)
.
Connect SFP Transceivers (Combo Ports 9-10)
on Page 14 for information about SFP installation.
All of the Ethernet ports automatically detect the signal from the connected devices to negotiate the link
speed and duplex mode (half- or full-duplex). Auto MDI/MDIX allows you to connect another switch, hub, or
workstation without changing straight-through or crossover cables. Crossover cables cross-connect the
transmit lines at each end to the received lines at the opposite end.
Connect one side of an Ethernet cable into any switch port and connect the other side to your attached device.
The LNK/ACT LED is lit when the cable is correctly connected. Always make sure that the cables between
the switches and attached devices (for example, switch, hub, or workstation) are less than 100 meters (328
feet) and meet these requirements.
•
10BASE-T: Category 3, 4, or 5 cable
•
100BASE-TX: Category 5 or 5e cable
•
1000BASE-TX: Category 5 or 5e cable
TX
D1
+
1
TX
D1
-
2
RX
D2
+
3
RX
D2
-
6
BI D3+ 4
BI D3- 5
BI D4+ 7
BI D4- 8
1
RX
D2
+
2
RX
D2
-
3
TX
D1
+
6
TX
D1
-
4 BI D4+
5 BI D4-
7 BI D3+
8 BI D3-
Straight-Through Cabling
TX
D1
+
1
TX
D1
-
2
RX
D2
+
3
RX
D2
-
6
BI D3+ 4
BI D3- 5
BI D4+ 7
BI D4- 8
1
RX
D2
+
2
RX
D2
-
3
TX
D1
+
6
TX
D1
-
4 BI D4+
5 BI D4-
7 BI D3+
8 BI D3-
Crossover Cabling
10/100BASE-TX
1000BASE-TX