Comtrol ES7510-XT - Manual (Page 165)

166 - Network Redundancy (CLI) RocketLinx ES7510-XT User Guide: 2000571 Rev. D
Configuration Using the Command Line Interface (CLI)
Redundant Ring
Create or
configure a Ring
Switch(config)# redundant-ring 1
Ring 1 created
Switch(config-redundant-ring)#
Note: 1 is the target Ring ID which is going to be created or configured.
Super Ring
Version
Switch(config-redundant-ring)# version
default set default to Redundant ring
rapid-super-ring rapid super ring
super-ring super ring
Switch(config-redundant-ring)# version rapid-super-ring
Priority
Switch(config-redundant-ring)# priority
<0-255> valid range is 0 to 255
default set default
Switch(config-redundant-ring)# super-ring priority 100
Ring Port
Switch(config-redundant-ring)# port
IFLIST Interface list, ex: fa1,fa3-5
cost path cost
Switch(config-redundant-ring)# port fa1,fa2
Ring Port Cost
Switch(config-redundant-ring)# port cost
<0-255> valid range is 0 or 255
default set default (128)valid range is 0 or 255
Switch(config-redundant-ring)# port cost 100
<0-255> valid range is 0 or 255
default set default (128)valid range is 0 or 255
Switch(config-redundant-ring)# port cost 100 200
Set path cost success.
Rapid Dual
Homing
Switch(config-redundant-ring)# rapid-dual-homing enable
Switch(config-redundant-ring)# rapid-dual-homing disable
Switch(config-redundant-ring)# rapid-dual-homing port
IFLIST Interface name, ex: fa1
auto-detect Uplink auto detection
IFNAME Interface name, ex: fa1
Switch(config-redundant-ring)# rapid-dual-homing port 3,5-6
set Rapid Dual Homing port success.
Note: Auto-detect is recommended for Dual Homing.