Comtrol ES7510-XT - Manual (Page 175)

176 - Traffic Prioritization (CLI) RocketLinx ES7510-XT User Guide: 2000571 Rev. D
Configuration Using the Command Line Interface (CLI)
QoS Setting (cont.)
Display – Port Setting -
Trust Mode
Switch# show qos trust
QoS Port Trust Mode :
Port Trust Mode
-----+------------
1 DSCP first
2 COS only
3 COS only
4 COS only
5 COS only
6 COS only
7 COS only
8 COS only
10 COS only
Display – Port Setting –
CoS (Port Default
Priority)
Switch# show qos port-cos
Port Default Cos :
Port CoS
-----+----
1 7
2 0
3 0
4 0
5 0
6 0
7 0
8 0
CoS-Queue Mapping
Format
Switch(config)# qos cos-map
PRIORITY Assign an priority (7 highest)
Switch(config)# qos cos-map 1
QUEUE Assign an queue (0-3)
Format: qos cos-map priority_value queue_value.
Map CoS 0 to Queue 1
Switch(config)# qos cos-map 0 1
The CoS to queue mapping is set ok.
Map CoS 1 to Queue 0
Switch(config)# qos cos-map 1 0
The CoS to queue mapping is set ok.
Map CoS 2 to Queue 0
Switch(config)# qos cos-map 2 0
The CoS to queue mapping is set ok.
Map CoS 3 to Queue 1
Switch(config)# qos cos-map 3 1
The CoS to queue mapping is set ok.
Map CoS 4 to Queue 2
Switch(config)# qos cos-map 4 2
The CoS to queue mapping is set ok.
Map CoS 5 to Queue 2
Switch(config)# qos cos-map 5 2
The CoS to queue mapping is set ok.
Map CoS 6 to Queue 3
Switch(config)# qos cos-map 6 3
The CoS to queue mapping is set ok.
Map CoS 7 to Queue 3
Switch(config)# qos cos-map 7 3
The CoS to queue mapping is set ok.