Comtrol ES8510-XT - Manual (Page 110)

110 - Warning RocketLinx ES8510 and ES8510-XT User Guide: 2000513 Rev. H
Configuration Using the Web Interface
Warning
The ES8510 provides several types of warning features for you to remotely monitor the status of the attached
devices or changes in your network. The features include Fault Relay, System Log and SMTP Email Alert.
The following web pages are included in this group:
• Fault Relay
• Event Selection on Page 112
• SysLog Configuration on Page 113
• SMTP Configuration on Page 114
Optionally, you can use the CLI for configuration, see Warnings (CLI) on Page 172.
Fault Relay
The ES8510 provides 2 digital outputs (also called relay outputs). The relay
contacts are energized (open) for normal operation and closes under fault
conditions. Fault conditions include Digital Input (DI) State, Dry Output, Power
Failure, Link Failure, Ping Failure, and Super Ring Failure. You can configure
these settings in this Fault Relay Setting. Each Relay can be assigned one fault
condition.
Relay 1: Click the check box for Relay 1 then select the Event Type and its
parameters.
Relay 2: Click the check box for Relay 2 then select the Event Type and its
parameters.
Event Type: Includes DI State, Dry Output, Power Failure, Link Failure, Ping
Failure, and Super Ring Failure. Each event type has its own parameters of
which you need to configure. Currently each relay can have one event type.
Event Type: DI State
DI Number: Select DI 1 or DI 2 to determine which DI you want to monitor.
DI State: Select whether you want to an event thrown when the voltage on
the DI is High or Low.
How to configure: Select the DI number and DI State you want to monitor. For example when DI 1 and High
are selected it means when DI 1’s voltage high the system shorts the relay output and light the DO LED.
Event Type: Dry Output
On Period (Sec): Type the period time to turn on relay output. The valid range is from 0 to 4294967295
seconds.