Comtrol ES8510-XT - Manual (Page 13)

RocketLinx ES8510 and ES8510-XT User Guide: 2000513 Rev. H Connect SFP Transceivers (Combo Ports 8-10) - 13
Hardware Installation
Connect SFP Transceivers (Combo Ports 8-10)
The ES8510 equips three SFP ports combined
with RJ45 Gigabit Ethernet ports (Ports 8-10).
The SFP ports accept standard mini GBIC SFP
transceivers that support 100BASE-FX/
1000BASE-X.
To ensure system reliability, Comtrol
recommends using
Comtrol certified SFP
Transceivers .
1. Plug the SFP transceiver into the SFP fiber
transceiver.
2. Connect the transmit channel to the receive
channel at each end.
3. Check the direction/angle of the fiber transceiver and the fiber cable.
Note: This is a Class 1 Laser/LED product. Do not stare at the Laser/LED Beam.
The SFP port does not function until the fiber cable is linked to another active device. The SFP and
corresponding RJ45 ports work in an exclusive mode. Traffic sent or received through the SFP module has
priority thus no traffic is sent or received over the corresponding RJ45 connection. To use the RJ45
connection, remove the corresponding SFP.
Multi-Mode cables should not exceed 2KM and Single-Mode cables should not exceed 30km.
LED Descriptions
This subsection provides information about the ES8510 LEDs. You can also refer to Device Front Panel on
Page 122 for information about using the web user interface to remotely view LED information.
LED Name LED On LED Blinking LED Off
Power 1
Power 2
Green: Power available No power
DO1 (Digital Output)
DO2 (Digital Output)
Red: DO activated DO not activated
DI1 (Digital Input)
DI2 (Digital Input)
Green: DI activated DI not activated
R.M. (ring master) Green: Working as a Ring
Master Green: Ring failed Ring function disabled or
the ES8510 is on a ring
but not the ring master
1 - 7 (Fast Ethernet)
Green: Linked to another
device
Amber: Full-Duplex
Green: Active traffic Not connected
Collision
8 - 10 (Gigabit)
SFP
RJ45
Green: Connected
Green: Active connection
Green: Active
connection
Green: Active
connection
Plugged in but not linked
up
Not connected
The SFP cage is 2 x1 design.
Link/
Speed