Privileged exec mode – Comtrol ES8510-XT User Manual
Page 132
132 - Privileged EXEC Mode
RocketLinx ES8510 and ES8510-XT User Guide: 2000513 Rev. H
Configuration Using the Command Line Interface (CLI)
Privileged EXEC Mode
If you type enable in User EXEC mode, you can access Privileged EXEC mode. In this mode, the ES8510 allows
you to view current configuration, reset default, reload switch, show system information, save configuration,
and enter Global Configuration mode.
Type the following commands and press the Enter key:
•
configure terminal to access Global Configuration mode (
•
exit to close the CLI.
•
? to see the command list.
•
list to review the Privileged EXEC mode commands and corresponding options.
For the complete list of commands and options, refer to
Switch>enable
Switch#
archive manage archive files
clear Reset functions
clock Configure time-of-day clock
configure Configuration from vty interface
copy Copy from one file to another
debug Debugging functions
disable Turn off privileged mode command
dot1x IEEE 802.1x standard access security control
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
list Print command list
no Negate a command or set its defaults
pager Terminal pager
ping Send echo messages
quit Exit current mode and down to previous mode
reboot Reboot system
reload copy a default-config file to replace the current one
show Show running system information
telnet Open a telnet connection
terminal Set terminal line parameters
traceroute Trace route to destination
write Write running configuration to memory, network, or terminal