Comtrol ES8510-XT - Manual (Page 173)

RocketLinx ES8510 and ES8510-XT User Guide: 2000513 Rev. H Warnings (CLI) - 173
Configuration Using the Command Line Interface (CLI)
Fault Relay Output (cont.)
Display
Switch# show relay 1
Relay Output Type : Port Link
Port : 1, 2, 3, 4
Switch# show relay 2
Relay Output Type : Super Ring
Event Selection
Event Selection
Switch(config)# warning-event
coldstart Switch cold start event
warmstart Switch warm start event
linkdown Switch link down event
linkup Switch link up event
authentication Authentication failure event
di Switch di event
fault-relay Switch fault relay event
loop-protect Switch loop protection event
power Switch power failure event
sfp Switch SFP event
ring Switch ring event
time-sync Switch time synchronize event
Example:
Cold Start event
Switch(config)# warning-event coldstart
Set cold start event enable ok.
Example:
Link Up event
Switch(config)# warning-event linkup
[IFNAME] Interface list, ex: fastethernet1 or gi8
Switch(config)# warning-event linkup fastethernet1
Set fa5 link up event enable ok.
Display
Switch# show warning-event
Warning Event:
Cold Start: Enabled
Warm Start: Disabled
Authentication Failure: Disabled
Link Down: fa4-5
Link Up: fa4-5
Power Failure:
Ring: Disabled
Fault Relay: Disabled
Time synchronize Failure: Disabled
SFP DDM: Enabled
DI: Disabled