Comtrol AT Command Set Rev A - Manual (Page 116)

AT Commands Reference Manual
Conexant 100722B
3-90
+PMH - Modem-on-Hold Enable
This command controls the selection of modem-on-hold in the modem. The action of the
modem in response to modem-on-hold events is determined by the state of this command
as well as the state of a negotiated handshake with a V.92-compliant server in V.92
Mode.
Syntax
+PMH=<value>
Defined Values
<value> Decimal number corresponding to the selected operation.
0 Modem-on-hold enabled in V.92 Mode.
(Default.)
1 Disabled modem-on-hold.
Result Codes
OK 0 or 1 in V.92 Mode (see the +MS command)
ERROR Otherwise.
Reporting Current or Selected Value
Command: +PMH?
Response: +PMH: <current value>
Example: +PMH: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PMH=?
Response: +PMH: (<value> range)
Example: +PMH: (0,1)