Comtrol AT Command Set Rev A - Manual (Page 185)

AT Commands Reference Manual
100722B Conexant 5-13
5.3.6 +FK - Session Termination
Syntax: +FK
The +FK command causes the DCE to terminate the session in an orderly manner. In
particular, the DCE will send a DCN message at the next opportunity and hang up. At the
end of the termination process, the DCE will report the +FHNG response with result code
(Table 5-5).
This operation can be invoked by using the cancel <CAN> character during Phase C data
reception (see prior section).
The DCE will wait until the current page completes, unless the reception is of unlimited
length; in that case, the DCE may halt reception and terminate the session at any time.
5.3.7 +FCIG - Set Polling ID
This command allows setting the Local Polling ID string used in a CIG frame. The syntax
of this command is identical to +FLID.
Write syntax: +FCIG="<local ID string>"
Valid value: 20-character ASCII string
Default value: Empty
5.3.8 +FLPL - Indicate a Document for Polling
This command allows setting up an answering modem to know that it has a document
available for polling. This allows a calling modem to receive this fax from the answerer.
The syntax is:
AT+FLPL=?
0,1
OK
AT+FLPL=1
OK
AT+FLPL?
1
5.3.9 +FSPL - Enable Polling
This command allows setting up an originating modem to be able to request to receive a
document from a polled station. The syntax is:
AT+FSPL=?
0,1
OK
AT+FSPL=1
OK
AT+FSPL?
1