Comtrol AT Command Set Rev A User Manual
Page 122
AT Commands Reference Manual
Conexant
100722B
3-96
-QCPC - Force Full Startup Procedure Next Connection
This command causes the modem to use full startup procedures on the next connection
attempt regardless of the setting of the +PQC command. After this attempt, the modem
will select the startup procedure as defined by the +PQC command. If a shortened startup
procedure is enabled by the +PQC command, then the quick connect profile will also be
updated on the next connection attempt.
Syntax
-QCPC
Result Code
OK
In V.92 Mode (+MS=V.92)
ERROR
Otherwise
-QCPS - Enable Quick Connect Profile Save
This command controls whether or not the modem will save the generated quick connect
profile.
Syntax
-QCPS=<value>
Defined Values
<value>
Decimal number corresponding to the desired operation.
0
Do not allow the quick connect profile to be
saved.
1
Allow the quick connect profile to be saved.
(Default.)
Result Codes
OK
0 or 1 in V.92 Mode (+MS=V.92) and quick connect is
enabled (+PSS = 0)
ERROR
Otherwise
Reporting Selected Value(s)
Command: -QCPS?
Response:
-QCPS: <value>
Example:
-QCPS: 1
For the default setting.
Reporting Supported Range of Parameter Values
Command: -QCPS=?
Response:
-QCPS: (<value> range)
Example:
-QCPS: (0,1)