Comtrol AT Command Set Rev A - Manual (Page 120)

AT Commands Reference Manual
Conexant 100722B
3-94
+PQC - V.92 Phase 1 and Phase 2 Control
This command controls the global enabling or disabling of the V.92 shortened Phase 1
and Phase 2 startup procedures. This command is used in conjunction with the +PSS
command.
Syntax
+PQC=<value>
Defined Values
<value> Decimal number corresponding to the selected setting.
0 Enable Short Phase 1 and Short Phase 2.
(Default.)
1 Enable Short Phase 1 only.
2 Not supported.
3 Disable Short Phase 1 and Short Phase 2.
Result Codes
OK 0, 1, or 3 in V.92 Mode (+MS=V.92)
ERROR Otherwise
Reporting Selected Values
Command: +PQC?
Response: +PQC: <value>
Example: +PQC: 0
Reporting Supported Range of Parameter Values
Command: +PQC=?
Response: +PQC: (<value> range)
Example: +PQC: (0,1,3)