Comtrol AT Command Set Rev A User Manual
Page 157
AT Commands Reference Manual
100722B
Conexant
4-7
+FAE - Auto Answer Enable
This command enables or disables fax adaptive answer. This command operates
identically to the +FAA command.
Syntax
+FAE=<value>
Defined Values
<value>
Decimal number corresponding to the selected option.
0
Disable data /fax auto answer mode. (Default.)
1
Enable data /fax auto answer mode. The modem
determines the calling type and issues DATA
result code (13) if the caller is a data modem or
issues FAX result code (15) if the caller is a fax
modem.
After a data (not fax) connection is achieved (indicated by the DATA result code), the
DTE must issue an ATO command to cause the modem to go on-line.
+FTS - Transmit Silence
This command causes the modem to terminate a transmission and wait for <time> 10-ms
intervals before responding with the OK result code.
Syntax
+FTS=<time>
Defined Values
<time>
Decimal number from 0 (default) to 255 which specifies the
length of time in 10-ms intervals to delay before responding
with the OK result code after terminating the session.
Result Codes
OK
Reported when transmission has been terminated for the
specified amount of time.
ERROR
<value> is invalid or this command is issued while the modem
is on-hook.
Reporting Supported Range of Parameter Values
Command: +FTS=?
Response:
+FTS: <time> range
Example:
+FTS: 0-255