Comtrol AT Command Set Rev A User Manual
Page 57
AT Commands Reference Manual
100722B
Conexant
3-31
+ILRR - DTE-Modem Local Rate Reporting
This extended-format numeric parameter controls whether or not the extended-format
+ILRR:<rate> information text is transmitted from the modem to the DTE.
Syntax
+ILRR=<value>
Defined Values
<value>
Decimal number corresponding to the selected option.
0
Disables reporting of local port rate (+ILRR: is
not transmitted). (Default.)
1
Enables reporting of local port rate (+ILRR: is
transmitted).
Reporting Current or Selected Values
Command: +ILRR?
Response:
+ILRR: <current value>
Example:
+ILRR: 0
For the default setting
Reporting Supported Range of Parameter Values
Command: +ILRR=?
Response:
+ILRR: (<value> range)
Example:
+ILRR: (0,1)
Reported Rate
The <rate> reported represents the current (negotiated or renegotiated) DTE-modem rate.
If enabled, the intermediate result code is transmitted after any modulation, error control
or data compression reports are transmitted, and before any final result code (e.g.,
CONNECT) is transmitted. The <rate> is applied after the final result code is transmitted.
The DTE-modem port rate will change only if neither buffered mode nor error controlled
means are enabled (+ES=x,0) and if the negotiated carrier rate (+MRR) does not match
the current DTE-modem port rate (autodetected from the previous command line).
Syntax
+ILRR: <rate>[,<rx_rate>]