Comtrol AT Command Set Rev A - Manual (Page 32)

AT Commands Reference Manual
Conexant 100722B
3-6
I - Identification
This command causes the modem to reports the requested result according to the
command parameter.
Syntax
I<value>
Defined Values
<value> Decimal number corresponding to the selected information.
0 Reports product code, e.g., “56000”.
1 Reports the least significant byte of the stored
checksum in decimal. Reports 255 if the
prestored checksum value is FFh.
2 Reports "OK".
3 Reports identification codes.
For the SmartACFL, SmartACF, and SC56D, the
codes are in the form RevisionName-
Modulation_Model, where:
RevisionName = product family
name_firmware version, i.e., ACF3. The
firmware version is in the form VX.XXX.
Example: ACF3_V1.000
Modulation = V90, V34, or V32 for
V.92/V.90, V.34, or V.32bis, respectively.
Model = Identifies RAM/ROM
configuration.
For the SmartSCM, the codes are in the form
RevisionName-Modulation, where:
RevisionName = masked firmware code
version. Example: P2109
Modulation = V90, V34, or V32 for V.90,
V.34, or V.32bis, respectively.
Examples:
ACF3_V1.000-V90_P21_FSH
P2109-V90
Note: If RPI+ is enabled (see +Hn),
“ROCKWELL RPI (TM) MODEM+01” is
appended.