Setting up remote management, Configuring ras tcp/ip for dialin – Comtrol DM ATS-NTe User Manual
Page 11
Installation and Setup
11
Setting Up Remote Management
Setting Up Remote Management
Before setting up remote management, make sure that you have already
performed the procedures in
Configuring Dialin for NetMeeting
on Page 10. The
ATS-NTE has the following drivers installed that require additional configuration
for remote management:
•
A standard 28.8 Kbps modem driver for AUX A with Remote Access Service
(RAS) enabled on COM2.
•
Xircom RealPort Modem 56 GlobalACCESS adapter driver that is installed on
COM3.
Review and perform the following procedures if you want to manage the ATS-NTE
from a remote (client) site:
•
Configuring RAS TCP/IP for Dialin (below)
•
Configuring RAS
TCP/IP for Dialin
To use NetMeeting on a dialin connection with AUX A or the Xircom modem, you
must change the RAS TCP/IP configuration.
Note: If you plan on configuring the Xircom CreditCard Wireless adapter, you
must enable the device (
on Page 41) before
any changes to the network bindings. Failure to do so before configuring
RAS will “orphan” the Xircom wireless adapter from the TCP/IP stack.
That is, this adapter will lose its pre=-configured binding to the network
protocols and services.
1.
Open the Network control panel and select the Services tab.
2.
Highlight Remote Access Service and select the Properties button.
3.
To configure a modem on AUX A, select the Network button and go to Step 5.
Note: If you want to configure the Xircom Modem 56-Global modem with Receive
calls only or Dial Out and Receive Calls capabilities, you must change
COM2 to a dial out only configuration.