Connecting optional devices to the ats- nte – Comtrol DM ATS-NTe User Manual
Page 6
Installation and Setup
6
Initial Hardware Installation to Configure the ATS-NTE
Follow the following procedures to setup the DeviceMaster ATS-NTE.
Note: If you need pin out information about any of the connectors on the ATS-
NTE, see
Initial Hardware
Installation to
Configure the ATS-
NTE
1.
Place the DeviceMaster ATS-NTE on a stable
surface or attach it to a suitable surface
using the mounting brackets shipped with
the device.
2.
Verify that the compact flash is fully
inserted. When installed correctly, the
compact flash is recessed into the ATS-NTE
and the eject button protrudes about 1/4
inch. If necessary, without using excessive
force or sharp objects, seat the compact flash
in its socket. Too much force can damage the
device.
3.
Connect the 15-pin monitor cable from a standard VGA monitor to the VGA
connector.
4.
Connect a standard PS/2 compatible keyboard (6-pin mini DIN) into the
KEYBOARD connector.
5.
Connect a PS/2 compatible mouse (6-pin mini DIN) into the MOUSE connector.
Connecting Optional
Devices to the ATS-
NTE
Connect the devices appropriate for how you plan to use the ATS-NTE:
1.
To dial-in and manage the ATS-NTE through a modem, connect an external
modem to the AUX A connector of the ATS-NTE.
If you want to connect a serial device (other than a modem) to this port, you
must turn off RAS and configure the port for your serial device. See
on Page 48 to change the default port set up.
2.
If you want to connect a parallel printer to the system, connect the printer
cable to the PARALLEL connector.
Note: The printer configuration supports the Epson
™
FX80.
3.
Optionally, insert one of the Comtrol approved PCMCIA devices into one of the
PCMCIA slots. The PCMCIA device must be inserted in the slot if you want to
configure the device in the following sections.
Note: The ATS-NTE PCMCIA option supports two Type II PCMCIA slots or
one Type III slot, which is installed at the factory. Drivers for Comtrol
approved PCMCIA devices are installed in the system.
•
Xircom® CreditCard™ Wireless Ethernet Adapter
Carefully align the adapter (with the flat side down, so that the Xircom
Activity and Status LEDs are visible from the top of the device) and gently
seat it into either the top or bottom rail of the PCMCIA slot.
•
Xircom RealPort™ Modem 56 GlobalACCESS Adapter
a.
Carefully align the adapter (with the flat side down, so that the
Xircom LED is on the left side) and gently seat it into the ATS-NTE.
b.
Connect the phone line.
Note: If you refer to the Xircom Quick Start card, please note that the
driver is already installed and configured as COM3.
•
PCMCIA to CompactFlash Adapter
a.
Insert a compact flash into the PCMCIA to CompactFlash adapter.
b.
Carefully align the PCMCIA adapter (compact flash facing up) with
the bottom rail and gently seat it into the ATS-NTE.