Comtrol DM ATS-NTe - Manual (Page 26)

PC104 RocketPort Option 26
Using the Modem Manufacturer’s Driver
Using the Modem
Manufacturer’s
Driver 1. If you want to use a modem driver that supports more than the standard
28800 bps default driver in the ATS-NTE, install the modem driver using the
manufacturer’s instructions.
2. Connect the modem to the serial port you want to configure.
The connector labeled P0 by default corresponds to COM4 (unless you changed
the starting COM port number in the driver setup to a higher number).
• COM1 is assigned to the CONSOLE port.
• COM2 is assigned to the AUX A port.
• COM3 is assigned to the PCMCIA Ethernet/modem cards.
3. Open the Modem control panel and select
the Add button.
4. Check the Don’t detect my modem... box
and select Next.
5. Select the modem manufacturer and model from the lists, and select Next.