Changing the default computer and workgroup names, Enter a new computer name and select ok, Reboot the system so that the changes take affect – Comtrol DM ATS-NTe User Manual
Page 9
Installation and Setup
9
Changing the Default Computer and Workgroup Names
3.
Before the ATS-NTE reboots, connect a standard Ethernet cable to the
Ethernet port (or ports) that corresponds to the port (or ports) configured in
The ports are labeled 1 and 2 (10/100 ETHERNET). For connector information,
see
on Page 54. After the ATS-NTE boots and is running,
the green LED indicates receive activity and the yellow LED indicates
transmit activity on the network.
Changing the Default Computer and Workgroup Names
If you plan on installing more than one ATS-NTE on your network, you must
change the default computer name.
1.
Right-click the Network Neighborhood
icon and select Properties.
2.
Select the Identification tab and the
Change button.
3.
Enter a new computer name and
select Ok.
4.
To change the Workgroup name, select
the Change button, enter a new
Workgroup name and select Ok.
5.
Reboot the system so that the changes
take affect.
Note: If you change the computer’s name
and you have installed the Xircom
CreditCard Wireless Ethernet
adapter, make sure that you change
the name in the Network control
panel (
on Page 42).