Comtrol DM ATS-NTe - Manual (Page 45)

Certified PCMCIA Adapters 45
Verifying the Ethernet Adapter Set Up
12. Select Enable WEP
(Wired Equivalent
Privacy).
Note: The Security
Level indicator
in the lower-left
corner of the
window should
change from all
black (No
Security) to all
green (Most
Secure)
13. Select Ok to close the
Properties window.
When the Client Utility
main screen returns,
the message at the
bottom should change
from:
Your CWE1100 is Not Associated!
to:
Your CWE1100 is Associated to MAC Address xx:xx:xx:xx:xx:xx
Where xx:xx:xx:xx:xx:xx is the MAC address of the wireless access point. If the
message does not change within a second or two, it may be necessary to move
the wireless adapter closer to the access point.
Verifying the
Ethernet Adapter
Set Up Use the following procedure to set up the device.
1. Before powering up the ATS-NTE again, confirm that the Xircom Wireless
Ethernet adapter is plugged into one of the two PCMCIA slots.
2. Repeat the power up and login sequence.
3. Open up the PCMCIA Control Panel.
4. Highlight the Xircom Wireless
Ethernet Adapter and select the
Properties button.
5. Select the Drivers tab, verify that the
driver is installed and started, and
then select the Ok button.
Note: If the driver has not been started, return to Enabling the Ethernet
Adapter on Page 41 and enable the adapter.
6. Select Ok to close the PCMCIA folder.