Under the commands menu, select enter wep key, Select ok to save, Select ok when finished and exit the utility – Comtrol DM ATS-NTe User Manual
Page 44: Select the network security tab
Certified PCMCIA Adapters
44
Enabling Wired Equivalent Privacy (WEP)
2.
Enter the password. The default password
is Xircom and it is case-sensitive.
3.
If the Xircom wireless adapter has never
been configured, the initial status screen
for the Client Encryption Manager should
show the following information:
Current Adapter is CWE1100 PCMCIA
Adapter's Firmware Does Support WEP
(Version V4.23)
Adapter is Configured
WEP is Disabled
WEP Key 1 is Not Set
WEP Key 2 is Not Set
WEP Key 3 is Not Set
WEP Key 4 is Not Set
WEP Tx Key is Key 1
4.
Under the Commands menu, select Enter WEP Key...
5.
Select the appropriate WEP Key
Size, set the WEP Key Type to
either Temporary or Permanent,
and enter the key value for Key
1 (with no spaces between the
characters).
•
For 128-bit encryption
(recommended), the WEP
value is 13 bytes (26
hexadecimal characters) in
length.
•
The WEP value is 5 bytes (10
hexadecimal characters) in
length for 40-bit encryption.
6.
Select Ok to save.
7.
Select Ok when finished and exit the utility.
8.
Double-click on the Xircom Wireless Ethernet Client Utility (WECU).
9.
When the initial client utility screen comes up, this message at the bottom of
the screen, Your CWE1100 is Not Associated!, which is expected behavior since
WEP has not yet been activated.
10. Under the Commands menu in the top menu bar, select Edit Properties...
11. Select the Network Security tab.