Futaba 4PK 2.4GHz - Manual (Page 110)

Normal condition 2nd condition
Normal condition 2nd condition
Copy
Abbreviation used on menu screen Function name, etc
D/R Dual rate function
ATL ATL function
STEXP Steering EXP
THEXP Throttle EXP (Forward side) EXP & VTR (not CRV)
STSPD Steering speed TURN & RETURN side
THSPD Throttle speed SPEED-LOW, MID, HIGH
A.B.S 2CH A.B.S. function ABS-ABP, ABS-DLY, ABSCYCLE
BRAKE Brake mixing (3CH,4CH) BRK-RATE, ABS-ABP, ABS-DLY
PMIX1 Program mixing 1 RGHT/BRAK/DOWN sides, LEFT/FWRD/UP sides
PMIX2 Program mixing 2 RGHT/BRAK/DOWN sides, LEFT/FWRD/UP sides
Related function
111
Fu
n
c
tio
n
System Functions "SYSTM"
About second condition function (2ND COND)
Two kinds of data can be set in one model for specific functions only. For example, two
kinds of data such as steering D/R set to 90% at normal condition and steering D/R set
to 80% at second condition. This second condition can be set for each model.
- To use the second condition function, setting "2ND-COND" to ACT (active) by "SYSTEM" and
switch setting by function select switch (page 86) are necessary.
- Switching from normal condition to second condition by switch set by function select switch is
indicated by an audible alarm.
- When switched to the second condition side, the LED blinks (does not blink when "LED-MODE"
setting by "SYSTEM" is OFF), and is displayed on the initial screen and menu screen and
the screen of the functions for which second condition can be set. When switched from second
condition to normal condition, an audible alarm sounds and the display disappears.
- After "2ND-COND" was set to ACT (active) by "SYSTEM" and switch setting was performed by
function select switch (page 86), all the normal condition data is copied to second condition only
when initially switched from nor-
mal condition to second condi-
tion by switch. Thereafter, normal
condition and second condition
can each set two kinds of data.
The items which can be set by
second condition are reverse displayed.
- Each data set by second condition is memorized until "2ND-COND" is changed to the INH (inhibit)
state by "SYSTEM", or the data
is reset by model setting (page
102). The data is memorized
even if switch setting by function
select switch is performed.