Futaba 4PK 2.4GHz - Manual (Page 84)

Full right Full left
A :Zone over which servo
does not operate
A A
85
Fu
n
c
tio
n
Programmable Mixes1, 2 "PMIX1, 2"
When the steering servo travel is insufficient even when D/R is 100% and EPA is 120%,
programmable mixing can be used to increase the travel somewhat.
(Reference data)
- PROG NIX1->ON
- MST (master channel) -> ST Mixing is applied from steering
- SLV (slave channel) ->ST Mixing is applied to steering and the travel is increased.
- RGHT -> 10% [When subtrim is centered (0%)]
- LEFT -> 10% [When subtrim is centered (0%)]
- OFST -> 0%
- MXMD -> MIX
- TRIM -> OFF
However, the operating range of the servo is exceeded
even if a large value is input at RIGHT and LEFT and a
zone over which the servo does not operate even when
the stick is moved to the left or right is created. A zone
over which the servo does not operate is also generated
at the moving side when the subtrim is moved to the left and right. Therefore, set the
RIGHT and LEFT value by checking servo operation.
When the throttle servo travel is insufficient at ATL 100% and EPA120%, the same ac-
tion can be performed by making TH (throttle) both the MST and SLV when steering.
When both steering and throttle operations are performed, use both PROG MIX1 and
PROG MIX2 program mixing.
When Steering and Throttle Travel is Insufficient
The mixing amount can be adjusted by using the function dial function (p.88).
Dial / Trim Setting
8
(Trim mode setup)
Select setup item "TRM" by (JOG) button up, down, left, or
right operation, and use the (+) or (-) button to select the
mixing mode.
"OFF" :Trim is added.
"ON" :Trim is removed.
9
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Trim mode (TRM)
OFF, ON
Initial value: OFF
Select the program mixing 1,2 function ON/OFF switch with the function select switch
function. (See page 86)
Switch Setting