Throttle exp "thexp, Fu n c tio n – Futaba 4PK 2.4GHz User Manual
Page 56
57
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t
he
button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t
he
button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
s3ELECT
button
* b l i n k s a t t h e c u r r e n t
setup item.
(EXP curve screen)
(VTR curve screen)
(CRV curve screen)
Throttle EXP "THEXP"
(Throttle system)
This function makes the throttle high side and brake side direction servo operation
quicker or milder. It has no effect on the servo maximum operation amount.
For the high side, selection from among three kinds of curves (EXP/VTR/CRV) is also
possible.
When the course conditions are good and the surface has good grip, set each curve to
the + side (quick side). When the road surface is slippery and the drive wheels do not
grip it, set each curve to the - minus (mild) side.
Advice
Throttle EXP "THEXP"
Curve selection
First, select the type of forward side curve at the "FWD-TYP"
item. The setup item (screen) varies with the type of curve.
The figure at the above is the EXP curve setup screen.
The throttle EXP curve and VTR curve adjustment (Foward side RATE) and(Brake
side RATE) can be controlled with digital dial DL1, DL2, DL3 or digital trim DT3 etc.
with the function select dial function. (See page 88)
Dial / Trim Setting
When "TRG-BRK" is set to "CUT OFF" by boat mode function (page 78), the brake
side function is not activated.
Caution
Curve selection
Curve type which operates the
throttle from the neutral point to
the high point on a curved curve.
Curve type which sets the switching
point between the throttle neutral
point and high point and operates
the throttle on a linear curve.
Curve type which sets 5 points
between the throttle neutral point
and high point and operates the
throttle.
s3ELECT
button
* blinks at the current setup item.