Futaba 4PK 2.4GHz - Manual (Page 13)

14
B
e
for
e
Using
After opening the box, first check if the contents conform to the following. The contents
depend on the set as shown below.
Set Contents
Transmitter T4PK
Receiver R604FS
Miscellaneous
Transmitter Ni-MH battery pack HT5F1700B
*Installed in transmitter.
Receiver switch
Wheel offset adapter(APA)
Hook
Instruction manual
- If any of the set contents are missing, or you have any questions, please contact
your dealer.
ｎ Caution
ｊ When using the T4PK in the high speed (HIGH SPEED) mode, always use it under the following
conditions:
Servos :6V Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :6V Ni-Cd battery
Transmitter mode :HIGH SPEED mode (See p.46 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
In addition, the FSU1 Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the
transmitter.
ｊ When using analog servos, always switch the T4PK servo response to the NORMAL mode.
Transmitter mode :NORMAL mode (See p.46 for setting method.)
Receiver’s battery :6V Ni-Cd battery
The set cannot operate in the HIGH SPEED mode. Operation in this mode will cause trouble of servo and other equipments.
Digital servos (including BLS Series brushless servos) can also be used in the NORMAL mode.
ｊ Always use only genuine Futaba transmitters, receivers, servos, ESCs (electronic speed con-
trols), Ni-MH(Ni-Cd) batteries and other optional accessories.
Futaba will not be responsible for problems caused by the use of other than Futaba genuine parts. Use the parts speci-
fied in the instruction manual and catalog.