Futaba 4PK 2.4GHz - Manual (Page 69)

L 50% 50% N R L 50% 50% N R
Steering operation Steering operation
A.B.S. operation range
indicated by " "
A.B.S. operation range
indicated by " "
A.B.S. operation range
indicated by " "
N50% E50%
Ser
v
o
tr
a
v
el
Trigger operation
ABP
(Amount of
brake return)
TGP (Trigger point)
CYC (Cycle)
DTY (duty): X and Y ratio
X: (Brake application time)
Y: (Brake return time)
A.B.S
70
Fu
n
c
tio
n
A.B.S Function "A.B.S"
- ABP : Amount of brake return
Sets the rate at which the ser-
vo returns versus trigger oper-
ation for brake release. When
set to 0%, the ABS function
is not performed. When set to
50%, the servo returns 50%
(1/2) of the trigger operation
amount and when set to 100%,
the servo returns to the neutral
position.
- DLY : Delay
Sets the delay from brake op-
eration to ABS operation. When set to 0%, the ABS function is activated without any
delay. At 50%, the ABS function is activated after a delay of approximately 0.7 second
and at 100%, the ABS function is activated after a delay of approximately 1.4 seconds.
- CYC : Cycle speed
Sets the pulse speed (cycle). The smaller the set value, the faster the pulse cycle.
- MODE : Function ON/OFF
ABS function ON/OFF setting. When using the ABS function, set to "ACT(ON)".
- TGP : Trigger point
Sets the trigger point at which the ABS function begins to operate at brake operation.
- DTY : Cycle duty ratio
Sets the proportion of the time the brakes are applied and the time the brakes are re-
leased by pulse operation. The ratio can be set to +3 ~ 0 ~ -3 in 7 steps.
- STM : Steering mixing
Sets ABS operation ON/OFF according to the steering operation range.