Futaba 4PK 2.4GHz - Manual (Page 76)

77
Fu
n
c
tio
n
Brake rate (STM-LFT/STM-RGT)
0 ~ 100
Initial value:100
Brake return amount (ABS-ABP)
0 ~ 50 ~ 100
Initial value; 50
"0" :No return
"50" :Return to the 50% position of
the brake operation amount
"100" :Return to the neutral position.
Delay amount (ABS-DLY)
0 ~ 100
Initial value; 0
"0" :A.B.S.
function performed
without any delay
"50" :A.B.S function performed
after an approximate 0.7
sec delay.
"100" :A.B.S. function performed
after an approximate 1.7
secs delay.
Function ON/OFF (ABS-MODE)
INH(OFF), ACT(ON), ACT(OFF)
5
(Steering mixing)
Use this function when you want to weaken the front brakes
when steering was operated.
Select the setting item "STM-
LFT" or "STM-RGT" by (JOG)
button up, down, left, or right
operation. Use the (+) or (-)
bu t t o n t o a d j u s t t h e b ra ke
amount.
Use "STM-RGT" (CH3)(CH4) to adjust the brake amount
relative to the steering right operation amount. The smaller
the value, the weaker the front brakes. Set value "100" is the
state in which steering mixing is not performed.
- The mixing amount can be adjusted from 0 to 100 range.
6
(3rd & 4th channels brake-A.B.S ON/OFF)
Select setup item "ABS-MODE(CH3)"or "(CH4)" by (JOG)
button up, down, left or right operation. Set the function to the
"ACT" state by pressing the (+) or (-) button.
7
(3rd & 4th channels brake-A.B.S return amount adjustment)
Select setup item "ABS-ABP(CH3)"or "(CH4)" by (JOG) but-
ton up, down, left or right operation, and use the (+) and (-)
buttons to adjust the return amount.
8
(3rd & 4th channels brake-A.B.S delay amount setup)
Select setup item "ABS-DLY(CH3)"or "(CH4)" by (JOG) but-
ton up, down, left or right operation, and use the (+) and (-)
buttons to adjust the delay amount.
9
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
The function select dial function can control the 3rd/4th channels brake rate (RATE),
delay amount (DLY), and 3rd channel brake-A.B.S return amount (ABP) ...etc setting
using button trim DL1, DL2, DL3 or digital trim DT3 etc. (See page 88)
When BIGCAR is selected on the "MENU-T" function (See page 38, 103), 3rd chan-
nel brake rate (RATE) adjustment is automatically assigned to dial DL3.
Dial / Trim Setting
Brake Mixing "BRAKE"