IC Realtime 4 Channel Forensic Network Video Recorder - Manual (Page 35)

26
Figure 4-16
In Figure 4-16，click Page Switch button, you can go to Figure 4-17.(Please note only SD1 and
SD2 protocol can go to the following interface.)
The direction button here ti to control the speed dome menu. The displayed button here may vary
due to different protocol. The button is grey if current protocol does not support this function. Use
up/down button to switch between menu items and use left/right button to change setup. Click
enter/exit menu button to go to or exit speed dome menu. Click Page Switch button, system goes
back to Figure 4-7.
Figure 4-17
4.1.8 PIP Setup
4.1.8.1 Video 1-4 PIP
You can view different channels on the PIP mode. You can follow the steps listed below.
a) From main menu->setting->general, check the navigation bar to enable navigation function.
Close general interface and then left click mouse on the preview interface, you can see an
interface shown as in Figure 4-18.
Figure 4-18
b) In Figure 4-18, click to set a mode and then click . Now system goes to PIP mode.
Tips:
z One the preview interface, right click mouse and then select View PIP mode, then click
on Figure 4-18. You can go to PIP mode.
z The PIP mode uses one channel as the main window. You can select channel 1/23/4
as the main picture.