IC Realtime 4 Channel Forensic Network Video Recorder User Manual
Page 60
51
see an interface is shown as in Figure 5-5. Here you can set start time and end time by
setting corresponding date setup.
z
Time format: There are two types: 24-hour mode or 12-hour mode.
z
Language: System supports various languages: Chinese (simplified), Chinese (Traditional),
English, Italian, Japanese, French, Spanish (All languages listed here are optional. Slight
difference maybe found in various series.)
z
HDD full: Here is for you to select working mode when hard disk is full. There are two options:
stop recording or rewrite. If current working HDD is overwritten or the current HDD is full
while the next HDD is no empty, then system stops recording, If the current HDD is full and
then next HDD is not empty, then system overwrites the previous files.
z
Pack duration: Here is for you to specify record duration. The value ranges from 1 to 120
minutes. Default value is 60 minutes.
z
Device No: When you are using one remote control (not included in the accessory bag) to
control several NVRs, you can give a name to each NVR for your management.
z
Video standard: There are two formats: NTSC and PAL.
z
Device ID: Please input a corresponding device name here.
z
LCD off: System auto turns off screen if it is idle for the specified time. The value ranges
from 0 to 120 minutes. The default setup is 10 minutes. Click the
button at the front panel
to turn on the screen.
z
Auto logout: Here is for you to set auto logout interval once login user remains inactive for a
specified time. Value ranges from 0 to 60 minutes. The default setup is 10 minutes.
z
Startup wizard: Once you check the box here, system will go to the startup wizard directly
when the system restarts the next time. Otherwise, it will go to the login interface.
z
Device ID: Please input a corresponding device name here.
z
LCD shutdown: Here you can set the LCD auto shutdown time after system is invalid for the
specified time.
z
Navigation bar: Check the box here, system displays the navigation bar on the interface.
z
IPC Time Sync: You can input an interval here to synchronize the NVR time and IPC time.
Note:
Since system time is very important, do not modify time casually unless there is a must!
Before your time modification, please stop record operation first!
After completing all the setups please click save button, system goes back to the previous menu.