IC Realtime 4 Channel Forensic Network Video Recorder - Manual (Page 41)

32
Now you can set Sniffer mode as COM and protocol is RC or other protocols. Click COM setting
button, you can see COM setup interface. See Figure 4-27.
Now you can set RS232 information. The COM function is the protocol and the baud rate, data
bit, stop bit shall be the same with the temperature humidity device. Click Save to save you setup.
Figure 4-27
In Figure 4-26, select PIP channel from the dropdown list and then click overlay setup button,
you can see the following interface. See Figure 4-28.
Check the preview or monitor mode after T/H (Temperature/humidity) and then click Set button to
set overlay position. Click Save button to exit.
Figure 4-28
Tips
z
In Figure 4-28, click Set button, you can set overlay position.
z Each channel can set its own overlay information. The channel 1-4 encode overlay position
is corresponding to the overlay effect of its own channel during the preview. The PIP overlay
position is corresponding to the 4-window and PIP preview overlay effect.