IC Realtime 4 Channel Forensic Network Video Recorder User Manual
Page 76
67
z
Record channel: System auto activates motion detection channel(s) to record once an alarm
occurs. Please make sure you have set MD record in Schedule interface(Main Menu-
>Setting->Schedule) and schedule record in manual record interface(Main Menu-
>Advanced->Manual Record)
z
PTZ activation: Here you can set PTZ movement when alarm occurs. You can only go to a
preset when there is a motion detect alarm. Click “select” button, you can see an interface is
shown as in
X305H305H305H
Figure 4-78
X
.
z
Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
z
Tour: Here you can enable tour function when alarm occurs. System one-window tour.
Please go to chapter 4.2.5.9 Display for tour interval setup.
z
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Please highlight icon
to select the corresponding function. After all the setups please click
save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in
each channel may not be the same.
In Figure 4-77, you can left click mouse and then drag it to set a region for motion detection.
Click Fn to switch between arm/withdraw motion detection. After setting, click enter button to exit.
Figure 4-76