Mopar K6860899 - Manual (Page 105)

1
WI­FI ROUTER
DODGE SPRINTER
PROCEDURE STEPS:
WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument
panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait
two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This
is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental
airbag deployment and possible serious or fatal injury.
NOTE: Using a test light, ensure the power outlet being used is ignition switched. Power must not be present
with the ignition in the OFF position.
1. Disconnect and isolate the battery negative cable.
2. Lower the sun visor (3) and remove the two retaining
bolts (4).
3. Remove the two upper retaining bolts (2) and remove
the upper storage tray from the vehicle.
4. Using a trim tool or equivalent, carefully pry the A­pillar
(2) away from the body side (1) enough to gain access
to the tether.
5. Remove the tether retaining bolt and remove the A­pil­
lar from the vehicle.
Oct 16, 2009 K6860899 Rev. 1
PRINT THIS VEHICLE INDEX