Mopar K6860899 - Manual (Page 23)

5
14. Solder (3) the connection (2) together using rosin core
solder (1).
15. Center the heat shrink tubing (2) over the solder joint
and heat using a heat gun. Heat the joint until the tub­
ing is tightly sealed and sealant (1) comes out of both
ends of the tubing.
16. Crimp the supplied ring terminal to the Wi­Fi Router
ground wire at the PDC.
17. Solder the ring terminal to the Wi­Fi Router ground
wire.
18. Attach the Wi­Fi Router ground wire to the negative
battery terminal stud.
19. Install the PDC back cover, being careful not to pinch
any wires between the PDC and the PDC cover.
20. Install the PDC, align the clips on the PDC with the
tabs on the mounting bracket.
21. Install the PDC top cover.
22. Connect the negative battery cable.
Feb 12, 2010 K6860899 Rev. 2