Mopar K6860899 - Manual (Page 30)

5
30. Install the quarter trim panel to the vehicle, ensuring
the clip retainers engage.
31. Route the antenna cable along the left side of the vehi­
cle, across the lower instrument panel brace and over
to the shifter housing at the cigarette lighter connector,
securing along the way and cut to the proper length.
32. Locate the cigarette lighter outlet wiring harness.
33. Cut each wire and remove 13 mm (0.5 in.) of insula­
tion from each wire that needs to be soldered/spliced.
34. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol­
dered area.
35. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
Oct 16, 2009 K6860899 Rev. 1