Mopar K6860899 - Manual (Page 37)

2
9. Install the Wi­Fi router bracket (1) under the passen­
ger seat with the provided materials.
10. Connect the wire harness to the Wi­Fi router bracket
harness.
11. Route the Wi­Fi power harness under the center con­
sole to the shifter housing and cut the harness to the
proper length. Ensure the harness is tucked under the
center console to minimize visible wire.
12. Locate the cigarette lighter outlet wiring harness.
13. Cut each wire and remove 13 mm (0.5 in.) of insula­
tion from each wire that needs to be soldered/spliced.
14. Place a piece of supplied adhesive lined heat shrink
tubing on one side of each cut wire. Insure the tubing
will be long enough to cover and seal the entire sol­
dered area.
CAUTION: Do not use acid core solder.
15. Solder the supplied fused pigtail to Wi­Fi power har­
ness power wire.
16. Place the strands of the power side wires overlapping
each other inside of the splice clip (1).
Oct 16, 2009 K6860899 Rev. 1